Answer: find the answer in the explanation
Explanation: The potential energy in a circuit between two points is the workdone in taking units positive charge from one point to the other in the circuit. Its S.I unit is Joule.
Because voltage of a battery or cell in a circuit is the potential energy difference across its terminal
The potential energy difference between two points is one volt, if the workdone in taking one Coulomb of positive charge from one point to the other is one Joule.
Two students walk out on the broken bridge together. As they reach the end of the bridge, what would happen to their gravitational potential energy.
A)Decrease
B)increase
C)Remain the same
D)None of the above
Answer: C
Explanation: I dont realy know what this means. but it will not increase because your not getting closer to earths center of gravity and not decreasing because your not high enough in the atmosphere.
Define Newton's third law:
A) states that forces=m Xa
B)states that all forces occur in pairs
C)states that forces keep moving until acted upon by unbalanced force
D)states that gravity affects all objects
Help please!!
Answer:
the answer is B
Explanation:
the law states that for every action there is an equal and opposite reaction. action and reaction forces always act on two two different bodies and therefore THEY ALWAYS EXIST IN PAIRS.
The law of conservation of energy states that
A. energy cannot be converted from one from to another
B. energy cannot be created or destroyed
C. energy resources must be used efficiently
D. energy is constantly being lost to friction
Answer:
B
Explanation:
Energy can not be destroyed only converted into another form of energy
HELP PLEASE GIVING 30 POINTS AND BRAINLIEST DUE VERY SOON!!
Answer:
3 is your anwser
Explanation:
Heat always flows from a what place to a what place
Answer:
Heat is always the transfer of energy from an object at a higher temperature to an object at a lower temperature.
Explanation:
Answer:
Heat flows from high temperature to low temperature
Explanation:
the answer also may vary it can also be the heat flows from a warmer to colder place
hope this helped!
The throwback PFD is which type?
Answer:a
Explanation:
The throwback PFD is a Type III PFD. This type of PFD is designed for calm, inland water, or where there is a good chance of quick rescue. THe correct option is C.
Type III PFDs will not turn unconscious wearers to a face-up position, so the wearer may have to tilt their head back to avoid turning face down.
Type III PFDs have the same minimum buoyancy as Type II PFD. Float coats, fishing vests, and vests designed for various water sports are examples of Type III PFDs. Some Type III PFDs are designed to be inflated upon entering the water.
Offshore life jackets of Type I are suited for all areas, notably open, choppy, or isolated regions where rescue may be delayed and offer the highest buoyancy. Near-shore vests of Type II PFDs are designed for calm inland water or situations where there is a good probability of prompt rescue. Throwable PFDs of Type IV are suitable for usage in open water as well as calm, heavily used inland waters where assistance is always available. Special-purpose PFDs known as Type Vs are made for activities like kayaking and whitewater rafting.
The throwback PFD is not a Type I PFD because it does not provide the most buoyancy and is not designed for all waters. It is not a Type II PFD because it is not intended for calm, inland water or where there is a good chance of quick rescue. It is not a Type IV PFD because it is not intended for calm, inland water with heavy boat traffic, where help is always present. It is not a Type V PFD because it is not designed for specific activities such as kayaking or whitewater rafting.
Therefore, the correct option is C. type III.
To learn more about PFDS click:
https://brainly.com/question/30098150
#SPJ6
What are two ways to increase impulse?
Answer:
increase the time the force acts or you could increase the number of temptations.
hope this helped!
For a reaction to occur what must happen to the energy in order to break the chemical bond
what is the equivalet tempreture of 0 kelvin in celcius scale
HELP NEED IT IN 5 MIN
Answer:
-273.15 degree celcius
Explanation:
Which statement best explains acceleration?
O A.
It is the total distance covered over a period of time.
B.
It is a change in velocity over a period of time.
Oc.
It is a change in displacement over a period of time.
OD.
It is a change in direction over a period of time.
Answer:
It is a change in velocity over a period of time.
Explanation:
It is measured in metres/second2 using an accelerometer.Can anyone help me with this question? ASAP
15 points
Explanation:
PRIMERO ENCUENTRAS LA COMPONENTE x
x = 5.9 m(cos62°) + 7.8 m(cos 29°) = 9.6 m
AHORA LA COMPONENTE y
y = 5.9 m(sen 62°) - 7.8 m(sen 29°) = 1.4 m
PARA ENCONTRAR DESPLAZAMIENTO:
R = [tex]\sqrt{(9.6 m)^{2} + (1.4 m)^{2}}[/tex] = 9.7 m
On which of the following objects, all sitting on the ground together, does
Earth exert a greater gravitational pull than a pencil? Check all that apply.
A. A basketball
B. A toothpick
C. A truck
D. A piece of paper
E. Your hand
Explanation:
a toothpick
A spherical mirror and a thin spherical lens have each a focal length of +10cm , the mirror and the lens are likely to be
Answer: Concave mirror and convex lens
Explanation: A spherical mirror and a thin spherical lens have each a focal length of +10cm, this means that distance of any object from the mirror is +10 metres.
While for the lens, the distance of any object to the other side of the lens is +10 metres. Therefore, the mirror is concave mirror and the lens is a convex lens.
3.If a force of 12 N is applied to an object with a mass of 2 kg, what will be its acceleration?
Answer:
6 m/s^{2}
Explanation:
The formula for force is
F = mass x acceleration
F = 12 N
mass = 2 kg
So, you can change the formula to solve for acceleration.
acceleration = F / mass
a = 12 N / 12 kg
a = 6 m/s^{2}
ANSWER QUICK 40 POINTSSSS
QUESTION 6
Why are the moon’s craters preserved?
A)The moon is windy.
B)There are tectonic plates shifting on the moon.
C)Water preserves them.
D)There are no longer live tectonics occurring on the moon.
QUESTION 7
Why do you see only one side of the moon from Earth?
A)The moon does not rotate.
B)The moon takes longer to rotate than to revolve around Earth.
C)The moon takes less time to rotate than to revolve around Earth.
D)The moon’s period of rotation and revolution are equal.
QUESTION 8
What is the best description of the side of the moon that faces Earth?
A)random
B)The same
C)goes through cycles
D)changes
QUESTION 9
In what position are the moon, the earth, and the sun during the first quarter moon?
A)The moon is between the sun and the earth.
B)Earth is between the sun and the moon.
C)The sun is between the earth and the moon.
D)The moon is to the side of the earth and the sun.
Answer:
For 6 its D
For 7 its A
For 8 its C
For 9 I think its B but Im not sure
a car travels 60 km in 2 hours 84 km the next 1 hour and then 68 km in 8.9 hours before reaching its destination what was the cars average speed in km / h
Answer:
17.8 km/hr
Explanation:
Average speed = distance / time
The total distance traveled is 60 km + 84 km + 68 km = 212 km.
The total time is 2 hr + 1 hr + 8.9 hr = 11.9 hr.
The average speed is 212 km / 11.9 hr = 17.8 km/hr
Can someone give me a situation where energy is being transferred, transformed or both? Thank you!
All engines operate at less than 100 percent efficiency because they
A. absorb heat
B. conduct heat
C. burn gasoline
D. emit heat
Answer:
It is B or D, but I may be leaning a little more towards D.
Explanation:
PLEASE HELP THIS IS MY LAST QUESTION!!! HELP ASAP!!
Which of these does NOT have gravity?
A. heat
B. an apple
C. a small moon
D. Earth's atmosphere
Answer: its A
Explanation: it cant be earths atmosphere because is it was we would be flouting
Answer:
a
Explanation:
In order to increase the speed in a gear system
the driven gear must be larger than the driving gear
the driving gear must be larger than the driven gear
the driving gear must be the same size as the driven gear
none of these
asap plz
plz asap
Answer:
the driving gear must be larger than the driven gear
Explanation:
Electric circuit questions,,, plz help me
A negative slope on the velocity vs. time graph indicates that the object is not
accelerating
A. True
B. False
Answer: False, I think
Explanation:
Well it depends. Its hard to say without a function of the graph. Given a velocity graph, the first derivative is the acceleration.
Negative slope on a velocity graph means you are going in the negative direction. And over time, your velocity per unit of time is also decreasing. That means we are accelerating in the negative direction
I am literally so confused on what the question is asking halp :(
Answer: B
Explanation: Distance/Time but if u want it easier its Velocity=Distance/Time or (Final Velocity -Starting Velocity)/Time
Which of the answers shows three examples of a physical change
Calculate the wavelength of an electron mass 9.1*10^-31kg moving with a velocity of 2.0*10^6m/s (h=6.63*10^-34Js) (Hint: De Broglie's wavelength)
Answer:
Wavelength, [tex]\lambda=3.64\times 10^{-10}\ m[/tex]
Explanation:
We have,
Velocity an electron is [tex]2\times 10^6\ m/s[/tex]
Mass of an electron is [tex]9.1\times 10^{-31}\ kg[/tex]
It is required to find the wavelength of electron. The De-Broglie wavelength of an electron is given by :
[tex]\lambda=\dfrac{h}{mv}[/tex]
h is Planck's constant
[tex]\lambda=\dfrac{6.63\times 10^{-34}}{9.1\times 10^{-31}\times 2\times 10^6}\\\\\lambda=3.64\times 10^{-10}\ m[/tex]
So, the wavelength of an electron is [tex]3.64\times 10^{-10}\ m[/tex].
The acceleration due to gravity on the Moon is less than the acceleration due to gravity on the Earth. Which of the following is true about the mass and weight of an astronaut on the Moon's surface, compared to Earth?
(A) Mass is less, weight is the same.
(B) Mass is the same, weight is less.
(C) Both mass and weight are less.
(D) Both mass and weight are the same.
(E) Mass is more, weight is less.
Answer:
(B) Mass is the same, weight is less.
Explanation:
Just took test
Giotto used foreshortening in order to:
O A. enhance the importance of his subjects.
O B. make his figures look more realistic.
O C. combine linear and aerial perspectives.
O D. guide the eye of the viewer.
SUBMIT
Answer:
I think B is the answer.
I WILL CHOOSE YOU AS THE BRAINIEST PLEASE ANSWER MY QUESTION
Identify that all objects exert a force of gravity on all other objects in the universe
Answer:
It's like the Earth pulling on you and keeping you on the ground. That pull is gravity at work. Every object in the universe that has mass exerts a gravitational pull, or force, on every other mass. The size of the pull depends on the masses of the objects.
Explanation:
Mercury has a mass of 3.3 e 23 kg and a radius of 2.44 e 6 m. Find Mercury's
gravitational field strength. Show your work (formula, rearrangement, work, answer,
unit, sig dig) (4)
12. Venus has a mass of 4.87 e 24 kg and a radius of 6.05 e 6 m. The gravitational field strength at the surface of Venus is what? m/s2
13. A small Styrofoam ball has a 2.26 nC charge (2.26 x 10°C). Find the electric field strength
5.00 cm (0.0500 m) from the ball. Show your work complete with formula, work, unit and
sig digs) (4)
Answer:
11.) g = 3.695 m/s^2
12.) g = 8.879 m/s^2
13.) E = 8127 N/C
Explanation:
11.) Given that the
Mercury mass M = 3.3 × 10^23kg
Radius r = 2.44 ×10^6 m
Gravitational constant G = 6.67408 × 10^-11 m3kg-1 s^-2
Gravitational field strength g can be calculated by using the formula below
g = GM/r^2
Substitutes all the parameters into the formula
g = (6.67408 × 10^-11 × 3.3 × 10^23)/(2.44×10^6)^2
g = 2.2×10^13/5.954×10^12
g = 3.695 m/s^2
12.) Given that the
Venus mass M = 4.87×10^24kg
Radius r = 6.05 × 10^6 m
Using the same formula for gravitational field strength g
g = GM/R2
Substitute all the parameters into the formula
g = (6.67408 × 10^-11 × 4.87×10^24)/(6.05×10^6)^2
g = 3.25×10^14/3.66×10^13
g = 8.879 m/s^2
13.) Given that the
Charge = 2.26 nC = 2.26×10^-9
Distance d = 0.05m
Electric field strength E can be calculated by using the formula below
E = Kq/d^2
Where
K = electrostatic constant 8.99 × 10^9 Nm2/C2
Substitutes all the parameters into the formula
E = (8.99 × 10^9 × 2.26×10^-9)/0.05^2
E = 20.3174/2.5×10^-3
E = 8126.96 N/C
The process of thinking that involves considering an overall general idea or theory and drawing specific conclusions or making specific predictions is called __________.
A. empiricism
B. deductive reasoning
C. scientific method
D. inductive reasoning
Answer:
Deductive reasoning
Explanation:
deductive reasoning
the process of thinking that involves considering an overall general idea or theory and drawing specific conclusions or making specific predictions about it