Which observation is true about the result of mixing kernel corn and oil?
A. The kernel dissolved in the oil.
B. The kernel corn floated above the oil
C. The kernel corn did not dissolve completely.
D. The kernel corn settled down at the bottom of the glass.

Answer:

Argon

Explanation:

Because, it is positioned down on the periodic table

Answer:

Argon

Explanation:

Answer:

The amplitude of the speedboat waves were larger then the Breeze waves. The frequency of the speedboats waves were lower than the breeze waves. the speedboat waves had more of an effect on the boat, which tells us the speedboat waves had more energy.

Explanation:

plz can i get brainliest:)

Answer:

speedboat waves artificail and waves by breezes natural

Explanation:

Answer:

4.74 mol

Explanation:

Molarity = [tex]\frac{mol}{L}[/tex]

2.01 M = [tex]\frac{mol}{2.36 L}[/tex]

(2.01 M)(2.36 L) = 4.74 mol

Answer:

Respiration in plants: The process of respiration in plants involves using the sugars produced during photosynthesis plus oxygen to produce energy for plant growth. In many ways, respiration is the opposite of photosynthesis. ... As with photosynthesis, plants get oxygen from the air through the stomata.

Transpiration in plants: The water eventually is released to the atmosphere as vapour via the plant's stomata — tiny, closeable, pore-like structures on the surfaces of leaves. Overall, this uptake of water at the roots, transport of water through plant tissues, and release of vapour by leaves is known as transpiration.

Sources (jic)

https://www.usgs.gov/special-topic/water-science-school/science/evapotranspiration-and-water-cycle

https://www.pthorticulture.com/en/training-center/basics-of-plant-respiration/

Good luck!!

Answer:

10.58 J/g-°C

Explanation:

To find the specific heat capacity of the metal, you need to know how much heat was lost when it reacted with water.

You know that there are 55.4 g of water, the initial temp. of water is 25°C, and the final temp. (the mixture's temp.) is 63.4°C.

You should also know that the specific heat capacity of water is 4.186 J/g-°C.

Plug this into the equation the q=mcΔT.

q = (55.4 g)(4.186 J/g-°C)(63.4°C - 25°C)

q = 8905.12896 J

If 8905.12896 J was gained by the water, then 8905.12896 J must have been lost from the metal.

You know that there are 23 g of the metal and that its initial temp. is 100°C.

Plug this information into q=mcΔT.

8905.12896 J = (23 g)(C)(63.4°C - 100°C)

C = 10.58 J/g-°C

*When you plug all of this into the calculator, it will result in a negative number but keep in mind that heat was LOST by the metal so 8905.12896 J  is essentially negative. So the negative cancels out.*

Answer:

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

E

BRAINLIEST PLEASE

Answer:

The more water vapor in the air parcel, the more condensation can occur, and therefore, more rain. ... The air parcel then loses more energy, causing more rainfall. Wind pushes air parcels even higher in the troposphere, where it is colder. The air parcels will then lose more energy and more rain can happen.

I think is FALSE, is that right?

i think A but if I'm wrong sorry

then if increasing then becoming spread out so letter A

tip

this is just a tip not the true answer but try to add the given number

Answer: The cleaning spray might have containing alcohol.

Explanation:

Some alcohol have the tendency to give an explosive effect on heating. According to the given situation, if the cleaning fluid is containing alcohol and when it had been exposed to air, oxygen and sun heat it will become unstable by producing peroxides which can explode the can in which they have been stored. So, in the given situation, the cleaning spray containing alcohol will explode due to intense heat.

Answer: When an inert gas is added to the system in equilibrium at constant pressure, then the total volume will increase.

Explanation:

Answer:

When a guy who shows a girl to much emotion, they get turned off.

Explanation:

Answer:

Calorie

Explanation:

This can mesure thermal energy

answer: yes I believe so

explain: I just think it is I have done this before

Answer:

CuCl2 + 2NaNO3 -------> Cu(NO3)2 + 2NaCl

hope this helps

good day mate

A buffer is primarily used to limit the pH change in a solution. Option A is correct.

A buffer is the solution which contains the weak acid and its conjugate base or weak base and its conjugate acid. It is designed to resist changes in pH when small amounts of acid or base are added to it.

When an acid or base is added to a buffer solution, the buffer components react with the added ions to minimize the impact on the solution's pH. If an acid is added, the buffer will react with the acid by accepting the H⁺ ions. If a base is added, the buffer will react with the base by donating H⁺ ions. In both cases, the buffer helps maintain the pH at a relatively stable level.

To prevent an acid from dissociating, is not accurate. A buffer does not prevent an acid from dissociating. In fact, the acid in a buffer solution is necessary to provide the conjugate base and maintain the buffer's pH buffering capacity.

To neutralize the pH of a solution, is also not accurate. A buffer does not neutralize the pH of a solution to a particular value. Instead, it resists significant changes in pH when small amounts of acid or base are added.

To prevent a salt from dissolving, is unrelated to the purpose of a buffer. A buffer is not used to prevent the dissolution of salts.

Hence, A. is the correct option.

To know more about buffer here

https://brainly.com/question/31847096

#SPJ2

Answer:

There are 7.5 moles of salt

Explanation:

5.0M means that in every liter of solution, there are 5 moles of salt. So, 1.5L of solution times 5 moles per liter equals 7.5 moles

Answer:

300

Explanation:

at least 300 molecules

Answer:

b because  i said so

Explanation:

Answer:

d. 12.3 grams of Al2O3

Explanation:

The balanced equation in this question is as follows:

4Al + 3O2 → 2Al2O3

In this equation above, 4 moles of Al produces 2 moles of Al2O3

However, the moles of Al2O3 must first be found using;

mole = mass/molar mass

Molar mass of Al = 27g/mol

mole = 6.50/27

= 0.241mol of Al.

Hence, if 4 moles of aluminum (limiting reagent) reacts to form 2 moles of aluminum oxide (Al2O3).

Then, 0.241mol of Al will produce (0.241 × 2/4) = 0.241/2 = 0.121mol of Al2O3.

Convert this mole value to molar mass using mole = mass/molar mass

Molar mass of Al2O3 = 27(2) + 16(3)

= 54 + 48

= 102g/mol

mass = molar mass × mole

mass = 102 × 0.121

mass of Al2O3 = 12.34grams.

Answer:

b???

Explanation:

Answer:

Pretty sure it A.

Explanation:

I just thought that cause what exactly does 'some later time' mean?

Answer:

60.0g Na2SO4

Na2SO4 molar mass 142.04g

divide 60.0 by 142.02

And you get the answer .422moles Na2SO4

let me know if you need more explanation

Answer:

Explanation:

The new pressure can be found by using the formula for Boyle's law which is

[tex]P_1V_1 = P_2V_2[/tex]

Since we're finding the new pressure

[tex]P_2 = \frac{P_1V_1}{V_2} \\[/tex]

We have

[tex]P_2 = \frac{900 \times 600}{800} = \frac{540000}{800} \\ = 675[/tex]

We have the final answer as

Hope this helps you

Answer:

Here we were given the weight of Ca as 80g

and the atomic mass of carbon is 40u(molar mass)

using the formula

where w is weight and m is molar mass

80/40

=2

therefore, there are 2 moles in 80g of calcium

Answer:

DUE TO GRAVITATIONAL COLLAPSE SOLAR SYSTEM IS FORMED , ORBITS ARE CURVED TRAJECTORIES AND SIZE AND COMPOSTION OF PLANET ARE VERY UNIQUE AND COMPOSED OF ROCKS AND METALS and evolution of solar system has began 4.5 billion years ago,due to gravitational collapse of a small particle from a giant cloud.

Recall the heat capacity equation:

q = mc∆T

We're given mass, specific heat capacity, as well as the change in temperature. All we need to do is plug the numbers into the variables and we'll have our answer!

Although this question doesn't try to trick you, more often than not questions regarding energy change will attempt to throw you off with specific heat capacity. It's extremely important to note the units of the specific heat capacity and ensure that the numbers you use are in those units. As an example, the specific heat capacity might be given to you in J/mol*K - in this case, you'd have to do some unit conversions with your given data in order to fit all the numbers. In this question, we're given the specific heat capacity in J/gºC, so we don't need to change anything since all of our data is already in these units.

Anyways, back to the actual question:

q = mc∆T

q = (8.50 * [tex]10^{2}[/tex]) * (0.900) * (94.6 - 22.8)

q = 54927 (J)

Remeber to include significant figures:

54927 = 5.49 * 10^4 (J)

The required energy is 5.49 * [tex]10^{4}[/tex] Joules, or 5.49 * [tex]10^{1}[/tex] kJ

Let me know if you need any of my work to be explained!

- Breezeツ

1 2 3 4 5 and how the question ask