You are a nurse giving a patient 0.75 cc per minute of a drug cocktail intravenously . A cc is 1ml of a solution . If the patient needs thr iv for 2 hours how many liters of this solution will you need to prepare

Answer:

Nervous system, Cardiac system, and the muscluar system

Explanation:

Answer:

add baking soda maybe

Explanation:

Answer and Explanation

__________________________________________________________

All of the Information below is not owned by me, it is owned by CCBCMD.

__________________________________________________________

Colas are also carbonated beverages. The carbonation can produce some carbonic acid in the  Cola, which would affect your results. Therefore, to ensure that you are only titrating the  phosphoric acid you will use de-carbonated soda. This can easily be obtained by gently  heating the soda, or as you may already know, by rapidly shaking the bottle. It is also important that we do not use diet Colas since the artificial sweeteners that they contain have  acidic functional groups that will also interfere with the titration.

__________________________________________________________

Use a 25.00-mL pipet to deliver exactly 25.00 mL of room temperature, de-carbonated

Cola into a 250-mL beaker. Check out a magnetic stir bar and gently add it to the

beaker. Place the beaker on a stir plate. Set up a pH meter so that the probe is   completely immersed, but in a way that the stir bar will not hit it. The tip of the probe

has a thin glass membrane. Handle it with care! Position the beaker so that the stir bar

is as close to the center of the beaker as possible for optimal stirring. It should stir

rapidly enough to ensure thorough mixing but not so rapidly as to cause splattering.

__________________________________________________________

Obtain about 75 mL of 0.0100 M NaOH in a beaker. Use this NaOH to fill a buret.

Remember that you should always rinse a buret 2-3 times with the solution that you are

about to put into it and remove air bubbles at the buret tip. If you do not remember how

The initial level of the NaOH should be at exactly

0.00 mL. Once the buret is ready, place it over the beaker containing the Cola

__________________________________________________________

Hope this helps! <3

__________________________________________________________

Answer:

The density (more precisely, the volumetric mass density; also known as specific mass), of a substance is its mass per unit volume.

Explanation:

boom hope it helps

Answer:

the amount per unit volume of a particular material is the answer!

Explanation:

Answer:

Explanation:

Answer:eighter a b or c

nah i am playing it is a

Explanation:

Answer:

A is correct i took the quiz

Explanation:

Na = 2 atoms

Cl = 2atoms

F = 2 atoms

Given

Skeleton equation(unbalanced equation) :

NaCl+F2⇒NaF+Cl2

Required

The number of atoms

Solution

We balance the reactions to find the reaction coefficient, which is then used to calculate the number of atoms in the reactants and products

Balanced equation

2NaCl + F2 → 2NaF + Cl2

A balanced reaction will show that the number of atoms in the reactants and products is the same

Na = 2 atoms

Cl = 2atoms

F = 2 atoms

Na = 2 atoms

F = 2 atoms

Cl = 2 atoms

Answer:

I believe it is A. The Periodic Table is organized in order of atomic number.

Explanation:

The number of moles of NaCl = 0.103

Given

6 gram sample of NaCl

Required

moles

Solution

The mole is the number of particles contained in a substance

1 mol = 6.02.10²³

Moles can also be determined from the amount of substance mass and its molar mass

mole = mass : molar mass

Molar mass of NaCl = 58.5 g/mol

Input the value :

mole = 6 g : 58.5 g/mol

mole = 0.103

Answer:

3.15N

Explanation:

We use this equation:

F= k∆x

Where ∆x refers to the amount or stretch or compression and k is the spring constant.

F = force

k = spring constant

∆x = change in length of spring

To find the value of F:

F= k∆x

F= 12.6x0.25

F= 3.15N

Answer:

All the answers you chose are correct

Explanation:

Answer:

I cant see the fist question but all that you chose are correct

Explanation:

Answer:

[tex]7.13\times 10^{-2}\ ft^2[/tex]

Explanation:

The area of a telescope lens is 6.668 × 10³ mm²

We need to convert the area in ft².

We know that,

[tex]1\ mm^2=1.07\times 10^{-5}\ ft^2[/tex]

It means,

[tex]6.668 \times 10^3\ mm^2=6.668 \times 10^3\times 1.07\times 10^{-5}\ ft^2\\\\=0.0713\ ft^2[/tex]

or

[tex]0.0713\ ft^2=7.13\times 10^{-2}\ ft^2[/tex]

So, the required answer is [tex]7.13\times 10^{-2}\ ft^2[/tex].

Answer:

77460 g

Explanation:

To solve this problem first we convert molecules into moles, using Avogadro's number:

3.47x10²⁶ molecules ÷ 6.023x10²³ molecules/mol = 576.12 moles

Then we convert 576.12 CuCl₂ moles into grams, using its molar mass:

576.12 mol * 134.45 g/mol = 77460 g

So the answer is 77460 g, or 77.46 kg.

The question is incomplete, the complete question is;

The student collects the H2(g) produced by the reaction and measures its volume over water at 298 K after carefully equalizing the water levels inside and outside the gas-collection tube, as shown in the diagram below. The volume is measured to be 45.6mL . The atmospheric pressure in the lab is measured as 765 torr , and the equilibrium vapor pressure of water at 298 K is 24 torr .(i) The pressure inside the tube due to the H2(g)

Answer:

741 torr

Explanation:

From the question we can see that the atmospheric pressure in the lab is 765 torr.

The vapour pressure of water = 24 torr

From Dalton's law of partial pressure, we know that;

Total pressure = Pressure of the H2 + Partial pressure of water vapour

Therefore;

Pressure of H2 = Total pressure - Partial pressure of water vapour

Pressure of H2 = 765 torr - 24 torr = 741 torr

Opinion and  and factless ideas  are not science and engineering practice as these are based on observations.

Observations are defined as a set of statements or facts which are recorded while conducting an experiment.Observations are made through sensing changes in the variables of the experiment.

It is specifically defined as an act of knowing or recording the changes in the variables of the experiment.Recording observations holds importance as recording observations avoid the experiment to be repeated over and over again.

It is important to note down observations so that the testing of hypothesis is made easier.There are four types of observations .Observations need to be descriptive and must be written in complete sentences and should include all the numerical data of the experiment.

Learn more about observations,here:

https://brainly.com/question/24547719

#SPJ6

Answer:

In a chemical reaction, only the atoms present in the reactants can end up in the products. No new atoms are created, and no atoms are destroyed. In a chemical reaction, reactants contact each other, bonds between atoms in the reactants are broken, and atoms rearrange and form new bonds to make the products.

Explanation:

consider marking me brainlist :)

3, 1, 5, 4, 3, spontaneous

Answer:

2.28794056 grams

I hope this helps

Answer:

Cation / metal

Explanation:

When we named ionic compound we always write cation first. Let's take an example.

Sodium chloride is ionic compound. The electronegativity of chlorine is 3.16 and for sodium is 0.93. There is large difference is present. That's why electron from sodium is transfer to the chlorine. Sodium becomes positive and chlorine becomes negative ion. Both atoms are bonded together electrostatic attraction occur between anion and cations and ionic compound is formed. When we naming it we write " sodium " first which indicate sodium cation ( Na⁺)  while anion which is Cl⁻ is always written at the end. When we naming ionic compound we ended the name of anion with "ide". Sodium indicate metal while chloride ion indicate non metal. it means metal comes first while naming ionic compound.

The answer to this question would be true.

Answer:

0.05859091769326505 moles Mn203

Explanation:

Sample Response: No, thermal energy is not being transferred by radiation in this image. The eggs are in direct contact with the metal pan, which is in direct contact with the gas flame, so this is conduction, not radiation. Radiation transfers thermal energy by electromagnetic waves, not by direct contact.

Explanation:

No, thermal energy is not being transferred by radiation in this image.

The eggs are in direct contact with the metal pan, which is in direct contact with the gas flame.

Thermal energy is being transferred by conduction.

Radiation transfers thermal energy by electromagnetic waves.

Radiation does not transfer thermal energy by direct contact.

Thermal energy is the heat energy that is produced with an increase in temperature. No, thermal energy is not transferred by radiation when eggs are cooked.

Radiation is the process of thermal energy transfer that emits heat in all directions and does not require an intervening medium to travel.

Thermal energy is not transferred by radiation in the image as the eggs are in contact with the pan and the pan is in direct contact with a flame that radiates the heat by conduction.

Therefore, heat transfers by conduction and not by radiation.

Learn more about conduction here:

https://brainly.com/question/9352790

Answer:

A tomato plant use photosynthesis to make food

Explanation:

Answer:

6,9

Explanation:

Answer:

true <3

Explanation:

Answer:

to increase their number of species on the Earth and want to go long and long

Answer:

Abiotic factors.

Explanation:

Answer: A. The oceans‘ tidal would be smaller because the moon would exert less gravitational pull on earths oceans.

Explanation:

i got it right :)

Answer:

15 moles  of CO₂

Explanation:

Given data:

Number of formula units = 8.9 ×10²⁴ formula units

Number of moles of CO₂ = ?

Solution:

The given problem will solve by using Avogadro number.

The number 6.022 × 10²³ is called Avogadro number.

1 mole = 6.022 × 10²³ formula units

8.9 ×10²⁴ formula units  × 1mol / 6.022 × 10²³ formula units

1.5 mol ×10¹ mol

15 moles