Answer:
he word that musicians use for frequency is pitch. The shorter the wavelength, the higher the frequency, and the higher the pitch, of the sound. In other words, short waves sound high; long waves sound low. ... In other words, it sounds higher
Explanation:
Two objects collide elastically. The first has a mass of 5.00kg and a
velocity of 8.00 m/s. The second has a mass of 2.50 kg and a velocity
of -4.00m/s. If the velocity of object 1 after the collision is -4.00m/s,
what is the velocity of object 2?
Answer:
Explanation:
General formula
m1 * vi + m2*v2 = m1*v3 + m2*v4
Givens
m1 = 5
m2 = 2.5
v1 = 8 m/s
v2 = - 4 m/s
v3 = -4 m/s
v4 = x
Solution
5 * 8 - 2.5 * 4 = 5 * -4 + 2.5*x
40 - 10 = -20 + 2.5x
30 = - 20 + 2.5x
50 = 2.5x
x = 50/2.5
x = 20 m/s in the positive direction
Remark
Does this answer make sense? It should. You have 5 kg moving 8m/s in the plus direction. That's a lot of momentum. In addition after the collision, it turns around which is more momentum needed.
It has to give up that extra momentum to the 2.5 kg mass.
Table is in the picture. and will mark brainstest.
Here is the question
Based on the information in the table, which combination of materials would make the most conductive and best insulated wire?
A) A zinc wire with glass insulation
B) A copper wire with rubber insulation
C) A plastic wire with plastic insulation
D) An aluminum wire with plastic insulation
Every second the sun gives out 400 million joules of energy, but how much of that actually reaches the earth?
Answer:
about 50 million
Explanation:
100% guessing lol
Answer:
the best thing about this place was to have the kids to do it and
Fig. 2.1 shows a hammer being used to drive a nail into a piece of wood.
hammer head
-nail
wood
Fig. 2.1
The mass of the hammer head is 0.15 kg.
The speed of the hammer head when it hits the nail is 8.0m/s.
The time for which the hammer head is in contact with the nail is 0.0015s.
The hammer head stops after hitting the nail.
(a) Calculate the change in momentum of the hammer head.
Answer:
ΔP = - 1.2 Ns
Explanation:
The change in momentum of the hammer head can be given as follows:
[tex]\Delta P = P_f - P_i\\[/tex]
where,
ΔP = Change in Momentum = ?
Pf = Final Momentum
Pi - Initial Momentum
Therefore,
[tex]\Delta P = mv_f - mv_i\\\Delta P = m(v_f - v_i)[/tex]
where,
m = mass of hammer head = 0.15 kg
vf = final speed of hammer = 0 m/s
vi = initial speed of hammer = 8 m/s
Therefore,
[tex]\Delta P = (0.15\ kg)(0\ m/s-8\ m/s)[/tex]
ΔP = - 1.2 Ns
Question:
Define Force
Force is push or pull....
thank you
when will he love me 
Answer:
When you go bald
Explanation:
Mention three bodies/organizations that need electricity 24 hours
There are three types of electricity – baseload, dispatchable, and variable
What is specific heat capacity?
A. The amount of energy required for a unit mass of a substance to
undergo a phase change from a liquid to a gas.
B. The amount of energy required to raise the temperature of 1 kg of
a substance 1 °C.
C. The amount of energy required for a unit mass of a substance to
undergo a phase change from solid to liquid.
O D. A physical change from one form (or phase) of matter to another.
Measure of how high or low a sound is
les
Answer the question below using Active Thinking,
Learning
. Read the question carefully to determine what is being asked, Circle and/or underline key information in each question.
• Read all the answer choices.
• Do not just pick the correct answer. Briefly explain why you did NOT choose the other three choices and then explain why ya
did choose your correct answer choice.
Plants compete for many different resources, including sunlight and water. Which of the following adaptations of a plant is most
likely to help the plant be successful in competing for water?
A. a broad, deep root system
B. a tall stem or trunk
C. the ability to produce fruit with seeds
D. colorful flowers
Explanation:
I'm corona positive and isolated feeling depressed just logged in to talk someone but people ignoring me thanks for this behaviour got disappointed bye everyone logging out had a great time
_______ are considered to be fluids.
Solids
Liquids only
Gases only
Liquids and gases
Answer:
liquids and gases
Explanation:
Liquids and gases are considered to be fluids because they yield to shearing forces, whereas solids resist them.
*Materials that regulate the flow of current through them *
1)Conductors
2)Insulators
3)Resistors
4)Electromagnets
Answer:
electromagnet
Explanation:
mark me as brainlest
PLEASE HELP MEEEE
The bending of waves due to a change in speed is called
a.
reflection.
b.
refraction.
c.
diffraction.
d.
interference.
Answer:
D
Explanation:
Interference is the interaction between waves that meet.
Consider two spinning tops with different radii. Both have the same linear instantaneous velocities at their edges. Which top has a smaller angular velocity? the top with the smaller radius because the radius of curvature is inversely proportional to the angular velocity the top with the smaller radius because the radius of curvature is directly proportional to the angular velocity the top with the larger radius because the radius of curvature is inversely proportional to the angular velocity The top with the larger radius because the radius of curvature is directly proportional to the angular velocity
Answer:
the top with the largest radius because the radius of curvature is inversely proportional to the angular velocity
Explanation:
Angular and linear velocity are related
v = w r
w = v / r
Therefore, if the linear velocity of the two is the same, the one with the smaller radius has the higher angular velocity.
When reviewing the answers, the correct one is:
the top with the largest radius because the radius of curvature is inversely proportional to the angular velocity
The top that has a smaller angular velocity is D. the top with the larger radius because the radius of curvature is directly proportional to the angular velocity.
It should be noted that the top that has a higher angular velocity will be the top with the smaller radius because the radius of curvature is inversely proportional to the angular velocity
On the other hand, since the two spinning tops have different radii while both have the same linear instantaneous velocities at their edges, then the top that has a smaller angular velocity is the top with the larger radius because the radius of curvature is directly proportional to the angular velocity.
Read related link on:
https://brainly.com/question/16903986
Two point charges, Q1 = -1.0 PC and Q2 = +3.0 PC, are placed as shown in the diagram.
What is the vertical component of the electric field at the origin? Let the constant k = 9.0 x
109Nm²/C2
2.2 m
2.1 m Q1
O A zero
O B. -2100 N/C
O
C. 2100 N/C
o D. -8900 N/C
E. 8900 N/C
NEED ANSWER NOW
NO LINK
Do convex lens converge or diverge the light rays?
Answer:
converge
plz mark me as brainliest.
Why do baseball pitchers throw the ball at an angle that is slightly above the horizontal if they want the ball to reach at approximately the same height as it was thrown when it gets to the batter?
Answer:
The angle above the horizontal at which the pitcher throws the ball determines the distance the ball travels before returning to the height at which it was thrown
Explanation:
The baseball is thrown as a projectile and the range, 'R', of the baseball which is the distance the baseball travels before the height above the ground returns to the initial height is given given as follows;
[tex]R = \dfrac{u^2 \cdot sin(2\cdot \theta )}{g}[/tex]
Where;
R = The range of the baseball = The horizontal distance away from the pitcher the ball reaches
u = The initial velocity with which the baseball was thrown
θ = The angle above horizontal a baseball pitcher throws the ball
g = The acceleration due to gravity ≈ 9.81 m/s²
From the the equation, when θ = 0, sin(θ) = sin(0) = 0 and the ball does not cover any horizontal distance before going lower than the height at which it was thrown, therefore, for the ball to travel further, the angle of launch, θ has to be larger than 0.
What is one way that testing helpes scientists determing which solution for a problem works best?
Explain how electricity is transmitted from the main source in relation to step up and step down transformers
Answer:
The electricity produced from the main source which is an electrical generator which is usually close a remote abundant source of natural energy or at a distant location away from the residential areas where the electricity is used
The step up transformer is the device used to raise the voltage and therefore lower the current of the of incoming generated electricity before it is transmitted through high tension cables so that the energy loss from source to destination is reduced and the electricity generated can applied where needed
However, the high voltage transmitted along power lines to reduce energy loss cannot be used as it is by the consumer, partly because it is very harmful in the event of an electric shock and can easily damage household electrical devices, therefore, the high voltage in the power lines is reversed back or lowered into voltages which can be used to power electrical devices in buildings with the use of a step-down transformer
Explanation:
Explain why locations near the North Pole experience weeks of sunlight in June with no sunsets.
Answer:
It happens because the Earth is tilted on its axis around 23 degrees therefore the sun normally never sets at north Pole in summers. The sun doesn't set at Arctic Circle on North pole from about April 19 to August 23 each year due to this phenomenon.
Transcranial magnetic stimulation (TMS) is a noninvasive technique used to stimulate regions of the human brain. A small coil is placed on the scalp, and a brief burst of current in the coil produces a rapidly changing magnetic field inside the brain. The induced emf can be sufficient to stimulate neuronal activity. One such device generates a magnetic field within the brain that rises from zero to 1.5 T in 120 ms. Determine the induced emf within a circle of tissue of radius 1.6 mm and that is perpendicular to the direction of the field.
Answer:
0.125 volts
Explanation:
The induced emf can be sufficient to stimulate neuronal activity.
One such device generates a magnetic field within the brain that rises from zero to 1.5 T in 120 ms.
We need to find the induced emf within a circle of tissue of radius 1.6 mm and that is perpendicular to the direction of the field. The formula for the induced emf is given by :
[tex]\epsilon=-\dfrac{d\phi}{dt}[/tex]
Where
[tex]\phi[/tex] is magnetic flux
So,
[tex]\epsilon=-\dfrac{d(BA)}{dt}\\\\=2\pi r\times \dfrac{dB}{dt}\\\\=2\pi \times 1.6\times 10^{-3}\times \dfrac{1.5-0}{120\times 10^{-3}}\\\\=0.125\ V[/tex]
So, the induced emf is equal to 0.125 volts.
Why can water dissolve some ionic compounds, like NH4Cl, as well as some nonionic compounds, like methanol?
Answer:
Water is polar molecule. ... The ionic compounds are dissolved as these ions attract the hydrogen( negative charge attraacts them) and oxygen (positive charge attracts them) whereas methanol is a polar molecule and forms hydrogen bond with water molecules and hence dissolves.
Explanation:
What is happening to the ATOMS INSIDE of a magnet that gives the
material its magnetic properties?
Answer:
The atoms are aligned in a particular direction
Explanation:
The atoms become aligned in a particular direction in regions called domains, thus resulting in an overall resultant magnetism due to the spin of the electrons.
Is Algae Biotic or Abiotic?
Answer: Biotic
Explanation: Because it's bacteria.
What is the energy of the 30 kg skateboarder at 2 m off the ground traveling at 3 m/s?
Can someone help me please
Answer:
b
Explanation:
Answer:i think its the 3rd one
Explanation:
When two magnets attract, they ___________.
A. Pull together
B. Change color
C. Break
D. Push apart
Answer:
A. Pull together
Explanation:
This is because the two magnets are unlike-poles so they attract to eachother
Which of the following orders represents the ordering found in an alphanumeric outline?
A. capital letters, Arabic numerals, Roman numerals, lowercase letters
B. Arabic numerals, capital letters, Roman numerals, lowercase letters
C. Roman numerals, lowercase letters, Arabic numerals, capital letters
D. Roman numerals, capital letters, Arabic numerals, lowercase letters
Answer: D
Explanation: It says that in the paragraph
Answer:
Roman numerals, capital letters, Arabic numerals, lowercase letters
Explanation:
PLS HELP MEEEE (NO LINKS PLEASE)
The difference between visible light and gamma rays is that
a.
the amplitude of visible light is greater.
c.
they travel through a different medium.
b.
the speed of gamma rays is greater.
d.
the frequency of gamma rays is greater.
Answer:
Gamma rays occupy the short-wavelength end of the spectrum; they can have wavelengths smaller than the nucleus of an atom. Visible light wavesare one-thousandths the width of human hair--about a million times longer than gamma rays. Radio waves, at the long-wavelength end of the spectrum, can be many meters long.
Answer:D "the frequency of gamma rays is greater."
Explanation:Trust
1. how many lines of symmetry does a square have?
2. how many lines of symmetry does a triangle have?
3. how many lines of symmetry does a pentagon have?
4. how many lines of symmetry does a hexagon?
Answer:
1) four lines
2) three lines
3) fives lines
4) six lines
Answer:
4
Explanation: