Someone please help me!!

Answer:

A lower pH of the mouth creates bad bacteria that eventually lead to decay of the tooth.  

It can be prevented by avoiding food that causes acidity.

Explanation:

Tooth decay is caused by the pH level in the mouth dropping below 5.5, meaning it is acidic. It can be prevented by brushing your teeth as toothpaste is an alkali which will neutralise the pH level in your mouth.

Hope this helps

Answer:

147.222 degrees C

Explanation:

assuming its  297 F it should be correct

The temperature outside is 297°F then this temperature in celsius is equal to 147.22 °C.

Temperature can be described as a physical quantity that expresses quantitatively the perceptions of hotness or coldness. The most general scales are the Celsius scale with (°C), the Fahrenheit scale (°F), and the Kelvin scale (K), the latter being used predominantly for scientific purposes.

Fahrenheit to Celsius formula can be used to change the temperature from the scale Fahrenheit to degrees Celsius.

The formula that can be used to convert Fahrenheit to Celsius is given below:

[tex]\dusplaystyle ^oC = (^oF - 32) \times \frac{5}{9}[/tex]

Here, F represents the temperature in Fahrenheit, and C represents the temperature in Celsius.

Given the temperature in Fahrenheit = 297 °F

[tex]\dusplaystyle T( ^oC) = (297 - 32) \times \frac{5}{9}[/tex]

T = 147.22 °C

Therefore, the given temperature in celsius is equal to 147.22 °C.

Learn more about temperature, here:

https://brainly.com/question/14453171

#SPJ2

Answer:

There are no oxygen

Explanation:

Hydro is used when naming hydrogen compound and oxo is used when naming oxygen compound

Answer:

Cooffee

Explanation:

the answer is coffee because coffee might be bitter

Answer:Coffee

Explanation:Water is neutral, while the other answers are mostly organic acids but salt water is neither acidic nor basic

Answer:

Explanation:

In case of Water there are strong hydrogen boding excist as result shows high boiling point, wher as in case of methane the there is no hydrogen bond and excist weak vanderwall attraction between the molcuels so the lower boiling point.

Answer:

D

Explanation:

Atomic radii decrease slightly and then start to increase.

Atomic radius of transition metals from left to right increases slightly then decreases. Thus it is not following the trend as for other periods. Hence, option c is correct.

Transition metals are d-block elements in periodic table. starting from group 3 to group 12. Transition metals are called so because they are in between gases and metals in periodic table.

All transition metals shows varying oxidation states.  For example, iron Fe shows +2 and +3 and copper shows +1, +2 and +3.  Transition metals are malleable, ductile and are good conductors of heat and electricity.

From left to right in a row in periodic table, the atomic radius decreases and electronegativity increases. However, this trend is not systematic in the case of transition metals where, the atomic radii increases first and then decreases.

To find more on transition metals, refer here:

https://brainly.com/question/14516782

#SPJ6

Your question is incomplete, but your complete question probably was:

Which is true of transition metals when moving from left to right on the periodic table

The d sublevels are not filled across the period.

The cation radii become larger across the period.

Atomic radii increase slightly and then start to decrease.

Atomic radii decrease slightly and then start to increase.

Answer:

C.

Explanation:

Butane (C4H10) has 3 C-C bonds in the carbon chain and 10 C-H bonds

Butane ([tex]C_4H_10[/tex]) has 3 C-C bonds in the carbon chain and 10 C-H bonds

Alkanes are saturated hydrocarbons. This means that their carbon atoms are joined to each other by single bonds.

Based on the diagram, butane is considered to be an alkane. It not only contains single covalent bonds, but also has carbon and hydrogen atoms present in its structure.

When comparing both structures to one another, isobutane is a branched chain, while butane is a linear chain.

Learn more about alkane here:

https://brainly.com/question/4260635

#SPJ2

Answer:

.743 g/mL

Explanation:

Hopefully this helps :)

Lithium=li

Iron=Fe

Helium=He

I don't say u must have to mark my ans as brainliest but if u think it has really helped u plz don't forget to thank me....

Answer:

lithium symbol=li helium= he and iron =i

Answer: A. 490.48mol

Explanation:

Using the ideal gas equation; PV =nRT

where P = Presssure = 200 atm

          V = Volume = 60L

          n = Number of moles

          R = Gas constant = 0.08206 L.atm/mol/K

          T = Temperature = 25 °C  + 273 = 298K

Make "n" the subject of the formular;

n =  PV /  RT

   =  200   x    60   /    0.08206 x  298

   =  490.73  mol, which is closest to  option A. 490.48mol

Answer:

may be the first one is a producer

Answer:

3. C6H12O6 → 2CH3CH2OH + 2CO2

Explanation:

 In fermentation a catabolic process occurs, where an organic substance (C6H12O6) is transformed into a simpler one (CH3CH2OH), through incomplete oxidation, which does not require oxygen. Sugars are transformed into ethyl alcohol and carbon dioxide.

The equation C₆H₁₂O₆ → 2CH₃CH₂OH + 2CO₂ represents fermentation

Fermentation is an enzyme catalyzed, metabolic process whereby organisms convert starch or sugar to alcohol or an acid anaerobically releasing energy.

In this process a large molecule is broken down to a smaller molecule.

Among the Equations given Equation 3  

C₆H₁₂O₆ → 2CH₃CH₂OH + 2CO₂

represents fermentation due to two reasons

To know more about Fermentation

https://brainly.com/question/13050729

#SPJ5

Answer:

D is the correct answer acidity

Explanation:

pH is the logarithmic measurement of the H3O+-concentration in water solutions.

By definition: pH = -log[H3O+]

Example: [H3O+] = 1.0*10-7 mol/L in neutral, pure water (at 25oC), so

pH = -log(H3O+) = -log(1.0*10-7) = 7.0

Answer:

Volume=mass in g /density

Answer: 40cm^3 or 40ml

Explanation:

[tex]Density=\frac{mass}{volume}[/tex]

so 5=200/V

V=200/5

V=40cm^3

Answer:

Freshly prepared ferrous sulphate is used in brown ring test, because if FeSO4 is stored or it is the old one then it reacts with atmospheric oxygen and gets oxidized to form a corrosive brown-yellow coating of basic ferric sulphate, which is an adduct of ferric oxide and ferric sulphate

HEYA FRIEND

.

.

HERE'S YOUR ANSWER

.

.

.

.

It is used in brown ring test because , if Fe2So4 is stored or it is old one then it reacts with atmospheric oxygen and gets oxidized to form a corrosive brown yellow coating of basic ferric sulphate , which is an adduct of ferric oxide and ferric sulphate.

.

✌✌✌

HOPE IT WILL HELP YOU UP

.

.

KATË

Answer:

Explanation:es porque las especies con nichos idénticos tienen las mismas necesidades, lo que significa que competirían exactamente por los mismos recursos.

Answer:

A cation that has a smaller radius than the atom.

Explanation: when electrons are removed from the outermost shell of a calcium atom, the atom becomes a cation that has a smaller radius than the atom.

When electrons are removed from the outermost shell of a calcium atom, the atom becomes  a cation that has a smaller radius than the atom. Therefore, the correct option is option D.

Atom, the smallest unit of matter that may be separated without releasing electrically charged particles. It is also the smallest unit of matter with the characteristics of a chemical element. As a result, the atom is indeed the fundamental building component of chemistry.

The majority of the atom comprises empty space. The rest of the structure is made up of a positive-charged nucleus of neutrons and protons surrounding by a cloud of electrons with negative charges. In comparison to electrons, the lightest energized particles in nature, the nuclei is small and dense. When electrons are removed from the outermost shell of a calcium atom, the atom becomes  a cation that has a smaller radius than the atom.

Therefore, the correct option is option D.

To know more about atom, here:

https://brainly.com/question/29712157

#SPJ6

Answer:

152

Explanation:

since it weighs 1.9 grams per [tex]cm^{3}[/tex] we get 80*1.9 which is 152 grams

Answer:

The 5R's are Reuse, Reduce, Recycle, Repair and Recover.

Answer and Explanation:

For computing the initial quantity of helium we have to apply the law of ideal gas which is shown below:

[tex]pV=nRT\[/tex]

[tex]n=\dfrac{pV}{RT}[/tex]

Now we have to compute the ratio between the initial and the final numbers of moles which is

[tex]\dfrac{n_1}{n_2}=\dfrac{\dfrac{p_1V_1}{RT_1}}{\dfrac{p_2V_2}{RT_2}}[/tex]

The statement defines that

[tex]T_1=T_2,~p_1=p_2.[/tex]

Therefore

[tex]\dfrac{n_1}{n_2}=\dfrac{V_1}{V_2}[/tex]

[tex]\dfrac{n_1}{3.8\times10^{-4}}=\dfrac{230}{860}\iff\\\\ n_1=\dfrac{3.8\times10^{-4}\times230}{860}[/tex]

[tex]\boxed{n_1\approx1.0\times10^{-4}~mol}[/tex]

And, the variables are known is starting volume and ending gas quantity

Answer:

beginning volume and ending quantity of gas

Explanation:

Answer:

Explanation:

V1/T1 =V2/T2    at constnant pressure

Answer:

c

Explanation:

Answer:

C. Rate = k[H2]^2[O2]

Explanation:

Rate law only cares about REACTANTS. Since, rate law can only be determined experimentally, I am assuming the given reaction mechanism is elementary reaction from which we can write the rate law.

Only H2 and O2 are part of rate law since they are reactants and also the coefficient in front of H2 goes as exponent on rate law to indicate the order of H2 in the reaction.

Rate= k [H2]^2 [O2]

According to the chemical equilibrium, the rate law for the given reaction is Rate = k[H₂]²[O₂] as  the concentration is dependent on both the reactants.

Chemical equilibrium is defined as the condition which arises during the course of a reversible chemical reaction with no net change in amount of reactants and products.A reversible chemical reaction is the one wherein the products as soon as they are formed react together to produce back the reactants.

At equilibrium, the two opposing reactions which take place take place at equal rates and there is no net change in amount of the substances which are involved in the chemical reaction.At equilibrium, the reaction is considered to be complete . Conditions which are required for equilibrium are given by quantitative formulation.

Factors which affect chemical equilibrium are change in concentration , change in pressure and temperature and presence of catalyst.

Learn more about chemical equilibrium,here:

https://brainly.com/question/4289021

#SPJ2

Answer:

Mark me brainliest

Answer:

12.78 or 12.80 mostly like 12.78

Explanation:

Answer:

Molar mass of BaSO4 = 137.3 + 32 + (16 ×4)

= 137.3 + 32 +64

= 233.3g/mol

Molar mass = mass/ number of moles

= 233.3 g/mol = mass/ 1 mol

mass = 233.3g

Hope this helps.

Answer:idioma equivocado ????

Explanation:

alkali metals

a.pex

yes