What does it mean to say that scientific models are open to change? (2 points)

a
Scientific models are usually not very accurate.

b
Scientific models can be adjusted when new information is found.

c
People can adjust scientific models to fit their personal beliefs.

d
Experimental results can be changed to fit the accepted model

Answer:  fuel and oxygen are reactants.

Explanation:

Answer:

fuel and oxygen

Explanation:

I take test

Answer:

D

Explanation:

With the collision, obviously Ball 2's velocity increased, while Ball 1 slowed down a little bit due to the impact. This decrease in velocity caused a decrease in Ball 1's Momentum. Satisfying both conditions, option D is right.

Answer:

100% efficiency, this could only happen if there was not any friction Simple Machines Inclined plane, wedge, screw, lever, pulley and wheel and axel they are the most basic devices for making work easier

Explanation:

Heres the best help i can give you There is a couple different ways to determine if a bond is ionic or covalent. By definition, an ionic bond is between a metal and a nonmetal, and a covalent bond is between 2 nonmetals. So you usually just look at the periodic table and determine whether your compound is made of a metal/nonmetal or is just 2 nonmetals

Answer:

5 mL

Explanation:

As this is a problem regarding dilutions, we can solve it using the following formula:

Where subscript 1 refers to the initial concentration and volume, while 2 refers to the final C and V. Meaning that in this case:

We input the data:

And solve for V₁:

Answer:

5 mL of 5.0 M H₂SO₄ (aq) are needed to prepare 100 mL of 0.25 M H₂SO₄ (aq).

Explanation:

In chemistry, dilution is the reduction of the concentration of a chemical in a solution.

Then, dilution consists of preparing a less concentrated solution from a more concentrated one, and it consists simply by adding more solvent to the same amount of solute. That is, the amount or mass of the solute is not changed, but the volume of the solvent varies: as more solvent is added, the concentration of the solute decreases, since the volume (and weight) of the solution increases.

A dilution is calculated by the expression:

Ci*Vi = Cf*Vf

where:

In this case, you know:

Replacing:

5 M*Vi = 0.25 M* 100 mL

Solving:

[tex]Vi= \frac{0.25 M*100 mL}{5 M}[/tex]

Vi= 5 mL

5 mL of 5.0 M H₂SO₄ (aq) are needed to prepare 100 mL of 0.25 M H₂SO₄ (aq).

Answer:

A) 122 atm

Explanation:

PV = nRT

Solve for P --> P = nRT/V

n = 10.0 mol + 5.0 mol = 15.0 mol

R = 0.08206 L atm / mol K

T = 25 + 273 = 298 K

V = 3.0

P = (15.0)(0.08206)(298) / (3.0) = 122 atm

Answer:

(a)  The unit cell edge length 0.421 nm

Explanation:

Lets calculate -:

Given -

density = [tex]3.58g/cm^3[/tex]

Molecular weight of MgO = 24.31 +16

                                           [tex]40.13 g/mole[/tex]

Avagadro number = [tex]6.022\times10^2^3[/tex]

In rock salt structure , there are four anions and four cations , hence Z=4 (Number of formula per unit cell)

Now, using the formula -

                     [tex]d=\frac{ZM}{N_Aa^3}[/tex]

               [tex]a=[\frac{ZM}{N_Ad}]]^\frac{1}{3}[/tex]

Now, putting the given values

   [tex]a=\frac{4\times40.13g/mole}{6.022\times10^2^3\times(3.58g/cm^3)}[/tex]

  [tex]4.21\times10^-^8 cm[/tex]

  = 0.421 nm

Hence , the unit cell edge length = 0.421 nm

The unit cell edge length of magnesium oxide (MgO) is equal to 0.421 nanometer.

Given the following data:

Scientific data:

To determine the unit cell edge length:

Mathematically, the unit cell edge length for a face-centered cubic (FCC) structure is given by the formula:

[tex]a=\sqrt[3]{\frac{ZM}{\rho N_A} }[/tex]

Where:

Substituting the given parameters into the formula, we have;

[tex]a=\sqrt[3]{\frac{4 \; \times \;40.31}{3.58\; \times \;6.02 \times 10^{23}} }\\\\a=\sqrt[3]{\frac{161.24}{2.16 \times 10^{24}}}\\\\a=\sqrt[3]{7.47 \times 10^{-23}} \\\\a=4.21 \times 10^{-8}\;meter[/tex]

Note: [tex]1 \;nanometer = 1 \times 10^{-9} \;meter[/tex]

a = 0.421 nanometer.

Read more: https://brainly.com/question/18877825

Jet streams can cause warmer air temperatures on coastal land areas when the tide changes direction.

Jet streams are short bands of high wind that travel across the globe from west to east.

On earth, the location of the jet stream is in the latitude of the tropopause.

Two polar jet streams are present near the north and south poles.

Two subtropical jet streams are present, closer to the equator,

These make the Earth's four principal jet streams.

Thus, the correct option is C.

Learn more about jet streams

https://brainly.com/question/861519

Answer:

asexual cell

Explanation:there are mainly 2 types sexual and asexual i would say asexual because they grow without another parent and don't have a nucleus.

Answer:

I think B

Explanation:

Red litmus paper is used more to find bases, blue litmus paper changes better when coming to find acids. So I believe it is B

The best approach best investigate whether substances are basic is to test each substance with red litmus paper.

Basic compounds are those which have a pH value in between the range of 7.1 to 14.

Red litmus paper changes its color from red to blue when comes in the contact of basic compounds. So to check the basicity of household substance we should use red litmus paper.

Hence test each substance with red litmus paper.

To know more about basic compounds, visit the below link:
https://brainly.com/question/14666717

Answer:

-411 kj

Explanation:

We solve by using this formula

∆U = ∆Q + ∆W

This formula is the first law of thermodynamics

Change in internal energy U = +241

Heat gained by system Q = 652

Putting the value into the equation

+241 = 652 + W

Workdone = 241 - 652

Workdone = -411 kj

Since work done is negative it means that work was done by the system

thats kinda hot not even gon'

Answer:

A and C

Explanation:

DNA is what makes up you and me and DNA is composed of four bases adenine, guanine, thymine, and cytosine. The others are not true.

Answer:

Kim:

Wendell:

Gonzalo:

Explanation:

did it on Edge.

Given :

A compound is found to be made up of 3.21 g Carbon and 1.02 g Oxygen.

To Find :

The percent composition from this data.

Solution :

We know, percentage composition is given by :

[tex]\%mass = \dfrac{mass}{mass of compound}\times 100[/tex]

So, percentage composition of Carbon is :

[tex]\%Carbon = \dfrac{3.21}{3.21+1.02}\times 100\\\\\%Carbon = \dfrac{3.21}{4.23}\times 100\\\\\%Carbon = 75.89 \%[/tex]

Since, compound is made up of Carbon and Oxygen.

So, %Oxygen is ( 100 - 75.89 )% = 24.11%

Hence, this is the required solution.

Answer:

As we know that

At STP

1 mole of any gas occupies 22.4L  

so

15.7L / 22.4L/mole = 0.7moles Cl2  

0.7moles x 6.022x10^23molecules/mole = 4.22x10^23molecules

hope it helps

The partial pressure inside a gas mixture shall consist of the notional pressure of that constituent gas if the whole quantity of its starting material alone was occupied at the same temperature. The partial gas pressure is a measure of thermodynamic action in the particles of a gas, and the calculation can be defined as follows:

Given:

[tex]\to \bold{ P_T=3.50 \ atm}\\\\\to \bold{P_B=1.25 \ atm}\\\\[/tex]

To find:

partial pressure=?

Solution:

Using formula: [tex]\bold{P_T=P_A+P_B}\\\\[/tex]

                   [tex]\to \bold{3.50=P_A+1.25}\\\\\to \bold{P_A=3.50-1.25}\\\\\to \bold{P_A=2.25}\\\\[/tex]

As we know that pressure is not negative and as [tex]\bold{P_T}[/tex] is total pressure so, it has a large value, and[tex]\bold{ P_A , P_B}[/tex] is partial.

Therefore, the final answer is "Option C".

Learn more:

brainly.com/question/1417176

Answer:

Mutation

Explanation:

Mutation refers to the change in the structure of a gene. This change occurs when changes are made in the base/nucleotide sequence on a gene.

An example of such error made during DNA replication are incorrectly paired nucleotides or insertion/deletion of nucleotides during replication.

Answer:

[tex]K^{+}[/tex] and [tex]NO_{3}^{-}[/tex]

Explanation:

The equation for the reaction is AgNO3(aq) + KCl(aq) ==> AgCl(s) + KNO3(aq)

With all the ions, it is

[tex]Ag^{+}[/tex](aq) + [tex]NO_{3} ^{-}[/tex](aq) + [tex]K^{+}[/tex](aq) + [tex]Cl^{-}[/tex](aq)  ==> AgCl(s) +

[tex]K^{+}[/tex] and [tex]NO_{3} ^{-}[/tex] do not change, so they are the spectator ions and are removed

The ionic equation is:

[tex]Ag^{+}[/tex](aq) + [tex]Cl^{-}[/tex](aq) ==> AgCl(s)

Answer: Ik its too late but the answer is yeast.

Explanation: Sugar is yeasts food. If you mix sugar with yeast, and put it in something such as bread, a bottle with a balloon over it, or etc. It will cause it to rise.

Answer:

1. Compress.

2. Fixed.

3. Melts.

4. Melting point.

5. Freezing point.

6. High.

7. Crystalline.

8. Lattice.

9. Unit cell.

10. Amorphous.

Explanation:

In science, matter can be defined as anything that has mass and occupies space. Any physical object that is found on earth is typically composed of matter. Matter are known to be made up of atoms and as a result has the property of existing in states.

Generally, matter exists in three (3) distinct or classical phases and these are;

1. Gas: it is the state of matter in which the physical substance has no definite shape or volume and as a result fills all available space. Also, gases are easily compressible and can flow. Examples of gases are hydrogen, oxygen, argon, nitrogen etc.

2. Liquid: it is the state of matter in which the physical substance can be poured and it takes the shape of its container. Also, liquids generally have a definite volume. Examples of liquids are urine, water, milk, blood etc.

3. Solid: it is the state of matter in which the physical substance has a definite shape and fixed volume but not compressible. Examples of solids are pen, screwdriver, television, car etc.

Filling the missing words (texts) of the question, we have;

Solids tend to be dense and difficult to compress. They do not flow or take the shape of their containers, like liquids do, because the particles in solids vibrate around fixed points. When a solid is heated until its particles vibrate so rapidly that they are no longer held in fixed positions, the solid melts. The melting point is the temperature at which a solid changes to a liquid. The melting and freezing point of a substance are at the same temperature. In general, ionic solids tend to have relatively high melting points, while molecular solids tend to have relatively low melting points. Most solids are crystalline. The particles are arranged in a pattern known as a crystal lattice. The smallest subunit of a crystal lattice is the unit cell. Some solids lack an ordered internal structure and are called amorphous solids.

Answer:

i think so

Explanation:

just eat them anyways

Answer: Yes they are

Explanation: Where's the picture?

Answer:

Yes.

Explanation:

Birds don't look much like humans on the outside. As you might expect, their insides are also different, even though their internal organs carry out the same basic functions human organs carry out.

Explanation:

seaborgium Is a type of corn that is grown in warm countries.

answer is SG

Answer:

269 u

Explanation:

Answer:

The volume of 5.0 g CO2 is 2.6 L CO2 at STP.

Explanation:

hope this helps :)

Answer:

See explanation

Explanation:

The use of Uranium - 234 to generate electricity depends on a fission reaction. The uranium nuclide is bombarded by fast moving neutrons leading to a chain reaction. Control rods and moderators are used to keep the nuclear reaction under control.

As the nuclear reaction proceeds, heat is generated and steam is consequently produced. This steam is used to turn a turbine and electricity is thereby generated.

Answer:

Rice is grown in rainy regions.

The river flooded the whole region.

He explored the region around the South Pole.

Explanation:

Hope this helped!

Explanation:

Transverse waves are always characterized by particle motion being perpendicular to wave motion. A longitudinal wave is a wave in which particles of the medium move in a direction parallel to the direction that the wave moves.