Write out each of the following numbers in the long form (Part 2): SHOW YOUR WORK
1) 5 * 10 ^ - 6
2) 9 * 10 ^ - 9
3) 3 * 10 ^ 5
4) 2 * 10 ^ - 4
5)8 * 10 ^ 8

Results are neither precised nor accurate.

In the Given Actual density of silver  =10.5 g / cm^3

Measured values of silver  density = 14.2 g/cm^3

14.0g/cm^3

7.25g/cm^3

We have to  find whether the measurements given are accurate or precise.

so , Density can be defined as the ratio of mass to volume. The formula for calculation of density is shown below :

Density = Mass / Volume

The units of density is generally g / ml.

The results are said to be accurate if our measured value exactly matches with our true value.

In case of precision ,all the measured values should be near to each other or should differ only by 0.1 or 0.2.

So in this case the measured values are not precised nor accurate because it does not matches with true value also.

Hence , the results are neither precised nor accurate.

To know more about  precise visit : https://brainly.com/question/15926220

#SPJ9

Answer:

because cycle is a prosess that goes through multiple stages

Explanation:

.

Answer:

0.954

Explanation:

1000 grams is 1 kg

954 grams is 954/1000 kg or 0.954

Answer:

The correct answer is HOF gas.

Explanation:

Based on the given information, the helium atoms effuses three times faster in comparison to the gas X.

The rate of effusion is determined by,

r is inversely proportional to 1/√M, here M is the molecular mass of the gas.

and r is inversely proportional to 1/t, here t is the time taken for effusion.

Thus, t is directly proportional to √M

The molecular mass of He is 4.

tHe = tX/3 (Here tx is the time taken for gas X)

The molecular mass of X is not known.

tX/tHe =√Mx/MHe

3 = √Mx/4

By squaring both the sides we get,

9 = Mx/4

Mx = 36

36 is the molecular mass of gas HOF, that is, (1+16+19 = 36). Hence, the gas X is 36.

Answer:

Proton

Explanation:

The kinetic energy of 429 kJ and the specific heat of the substance is 9059 g kJ °C

The kinetic energy is given as ,

K.E = 1/2 m[tex]v^{2}[/tex]

Where m = mass = 1599 kg

v = velocity  = 83.4 km/h = 23 m/s

Putting the value mass and velocity in equation ( i ) we get ,

K.E = 1/2 × 1599 kg × 23 m/s × 23 m/s = 429074.86 J = 429 kJ

Specific heat is calculated as ,

Q = mcΔT

mass of the substance ( m ) = 56.87 g

c = 1475 J

ΔT = 138.4 °C - 30.0 °C = 108 °C.

Putting the value of mass , change in temperature and heat absorbed in equation ( ii ) we get ,

Q = 56.87 g × 1475 J × 108 °C = 9059391 gJ°C = 9059 g kJ °C

learn about kinetic energy

https://brainly.com/question/12669551

#SPJ1

Answer:

Osmosis is a process which occurs when there is a difference in solute concentration between two solutions separated by a semipermeable membrane. A semipermeable membrane allows passage of water but not of solutes. The passage of water occurs because of a pressure difference of water between the two solutions

Answer:

234.213

Explanation:

Moles of Nickel x 58.70 = Grams

3.99 x 58.70 = 234.213

Answer:

c

Explanation:

use %composition given to calculate emperical 4mular

The empirical formula of the compound having 57.5% Na, 40.0% O, and 2.5% H is NaOH (Option C)

Divide by their molar mass

Na = 57.5 / 23 = 2.5

O = 40 / 16 = 2.5

H = 2.5 / 1 = 2.6

Divide by the smallest

Na = 2.5 / 2.5 = 1

O = 2.5 / 2.5 = 1

H = 2.5 / 2.5 = 1

Thus, the empirical formula of the compound is NaOH

Learn more about empirical formula:

https://brainly.com/question/24297883

#SPJ2

Answer:

1.67 moles

Explanation:

From the balanced equation of reaction:

                     [tex]SO_2 + 2H_2S -> 3S + 2H_2O[/tex]

1 mole of sulfur dioxide, SO2, is required to produce 3 moles of sulfur, S.

If 1 mole SO2 = 3 moles S, then, how many moles of SO2 would be required for 5 moles S?

     Moles of SO2 needed = 5 x 1/3

                   = 5/3 or 1.67 moles

Hence, 1.67 moles of SO2 would be required to produce 5.0 moles of S.

Answer: 1.7

Explanation:

Explanation:

Cellulose fibers, structural proteins, and other polysaccharides help to maintain the shape and form of the cell. Additional functions of the cell wall include: Support: The cell wall provides mechanical strength and support. It also controls the direction of cell growth.

Answer:

the answer is your a awesome person

b is your best bet hope this helps

In the given question, the sulphuric acid which is needed to be produced is 408.333 Litres. NaCl + H₂SO₄ → HCl + NaHSO₄

This question is based on stoichiometry, in which we first balance the equation, equate the moles or the masses of elements and using the mole ratio or mass ratio, find the given amount of weight or moles of the desired element from the reaction. Stoichiometry helps us to predict the reaction components that how much it participates in the reaction, how much we the get the product or how much reactant is left. So, in the given question,
Equating the Molar masses: 58 + 98 → 36 + 120. Mass of HCl =[tex]500*0.8= 400[/tex] kg. Balancing the mass:

[tex]400[(58/120)+(98/120)][/tex] → [tex]400[(36/120)+(120/120)][/tex]

Volume of H₂SO₄ 80% = [tex]400 * (98/120)] /0.8= 408.333[/tex]

The final answer is 408.333 Litres. This was solved using Stoichiometry.

Learn more about Molar mass and Stoichiometry here:

https://brainly.com/question/28264019

#SPJ9

The percent mass of lead in tetraethyl lead is 64.1%.

The percent by mass of an element in a compound is determined by taking the ratio of the atomic mass of the element and the molar mass of the compound and then multiply by 100%

atomic mass of Pb = 207

atomic mass of C = 12

atomic mass of H = 1

Molar mass of  tetraethyl lead: 207 + 12 * 2 * 4  + 1 * 5 * 4

Molar mass of  tetraethyl lead = 323 g/mol

Percent mass of Pb = 207/323 × 100%

Percent mass of Pb = 0.6408 × 100%

Percent mass of Pb = 64.1%

In conclusion, the percent mass of lead in tetraethyl lead is 64.1%.

Learn more about percent mass at: brainly.com/question/5394922

#SPJ1

The acceleration of the cylinder in m/s2 is 0.973 meters per seconds squared.

Acceleration is the change of velocity with time. The unit is usually meters per seconds squared.

mass = 4.3 kg

radius = 0.4m

angle of inclination, ∅ = 0.15 radians

acceleration of the cylinder in m/s^2

= ( g + sin ∅ ) / 1 + 0.5

= ( 9.81 + sin 0.15 ) / 1.5

take note angle is in radians not degrees

= 1.46 / 1.5

= 0.973 meters per seconds squared

Read more on acceleration here: https://brainly.com/question/605631

#SPJ1

When 25.0g of Zn reacts, mols of HCl are consumed 0.7648 moles HCl

Write down the balanced chemical equation for this one replacement reaction first.

Zn(s)+2HCl(aq)→ZnCl2(aq)+H2(g)↑⏐

Now take note of the 2:1 mole ratio of reaction between the two reactants. This demonstrates that the reaction will always use up two times as much hydrochloric acid as zinc metal.

As you are aware, a solution's molarity indicates the number of moles of solute—in your case, hydrochloric acid, HCl—that are present in one liter of the solution.

The molarity of the hydrochloric acid solution is reported to be

3.05 mol L−1. This indicates that for every 1 L of solution, 3.05 moles of hydrochloric acid are produced. Remember this for later. You are aware that the reaction needs 25.0 g of zinc.

By using the molar mass of zinc, you can convert this mass to moles.

25 g per mole Zn

65.38g = 3.824 moles of zinc

n order for this many moles of zinc to react, you'd need

0.3824moles Zn⋅2amoles

HCl 1 mole Zn=0.7648 moles HCl

Learn more about reaction here-

https://brainly.com/question/17434463

#SPJ9

Answer:

i think c

Explanation:

:D

Answer:

C)a mass number of 38

Explanation:

yes

Answer:

Charles's law

Explanation:

The chemical equation given is that of Charles's law;

  The law states that "the volume of a fixed mass of a gas varies directly as its absolute temperature if the pressure is constant"

      mathematically;

              v ∝  T ( P, n constant)

So;

        V1/T1 = V2/T2

V and T are volume and temperature values

1 and 2 are initial and final states

Answer:

A chemical change has occurred

Explanation:

Given reaction expression:

      CaCO₃ →  CaO  +  CO₂

The reaction is a decomposition reaction in which a compound is dissociated into simple products.

The reason why the products have different properties than the reactants is because a chemical change has occurred.

The products of the decomposition of calcium carbonate have different properties because a chemical change has occured in the reaction to form new substances.

Learn more about chemical change at: https://brainly.com/question/1161517?referrer=searchResults

The concentration of OH⁻ ions will become 10 times the initial concentration.

A more useful approach to express the concentration of hydrogen ions is on the pH scale, which is the logarithm of the reciprocal of the hydrogen ion concentration in gram moles per liter. The concentrations of the hydrogen ion (H+) and the hydroxyl ion (OH) are both equal to 10⁻⁷ in a neutral solution. The pH of seven is neutral.

Solution pH 1 equals 8.

Solution's pH is 2 = 9.

pOH₁ = 14 - 8 = 6

pOH₂ = 14 - 9 = 5

OH₁⁻ = 10⁻⁶

OH₂⁻ = 10⁻⁵

Ratio = 10⁻⁵ / 10⁻⁶ = 10

To learn more about concentration of hydrogen ions from given link

https://brainly.com/question/4680271

#SPJ4

Answer:

temperature

amount

Explanation:

Under the postulate of Boyle's law, both temperature and amount(number of moles) are kept constant.

  According to Boyle's law "the volume of a fixed mass of gas varies inversely as the pressure changes if the temperature is constant"

 Based on the premise of this law, both temperature and amount of substance is kept constant.

Answer:

Ultraviolet

Explanation:

It doesn't use much energy and so it creates ultraviolet light.

Answer:

True

True

Temperature

Explanation:

Answer:

Thermal energy (also called heat energy) is produced when a rise in temperature causes atoms and molecules to move faster and collide with each other. The energy that comes from the temperature of the heated substance is called thermal energy.

Explanation:

will this help you